|
Installation Instructions
Checking your
injector connectors.
IT is imperative to verify the type
of injector your vehicle has.
(Click the connector to see a larger
version)
 |
 |
 |
 |
 |
 |
| EV1 Low Profile |
EV6 |
Toyota |
Honda |
Delphi Mini |
Nippon Denso |
Spark
Plugs and Spark Plug Cables:
They should be kept with the same
thermal degree indicated by the engine manufacturer; this should not be
altered. They should be changed at manufacturers recommended intervals.
Fuel,
oil and engine oil filters:
They should be changed for the engine safety and user comfort sake. It
is recommended to make the change at the first 625 miles after the Full
Flex Gold installation, because the oil filter and
fuel filter can be contaminated with the sludge caused by gasoline. From
then on, the change should be made at manufacturers recommended intervals.
Engine:
In spite of the higher consumption per mile traveled, the ethanol is
cleaner and does not cause problems and if used in an E85 mix it will
promote better lubrication of the parts in contact with the mixture and
thus, will increase the engine useful life and ensure a significant
increase in fuel economy.
"The engine that runs on ethanol and
gasoline is more economical, ensures a long useful life due to the low
contamination of oil and most importantly, is pollution free".
Fuel
Pump:
Check the fuel pump pressure and flow. These items are important for
the good operation of the system. The fuel pump should be in accordance
and within the standards set by the vehicle manufacturer. After confirming
the compliance of the data above, you may proceed with the Full Flex
Gold installation.
The use of ethanol reduces the vehicles
original fuel pump useful life, Serious wear can occur due to the
removing of the deposits left by the gasoline impurities in the fuel
tank.
Injectors:
The injectors should not be cleaned .The injectors are gauged to run
under the normal pressure of 3.0 bar, with 5% tolerance; a low tolerance
that if not respected, can cause losses: increased consumption, poor
vehicle performance, bumps while changing gears and difficulty to reach
the maximum speed.
Polarity:
The polarity of the injectors is important; some vehicle manufacturers
invert the feeding, thus causing problems when you have to install some
equipment. However, Full Flex Gold recognizes the
polarity automatically, as well as the injection nozzle resistance and the
current used, thus avoiding problems during the product installation.
Oxygen sensor:
It should be in perfect operating condition, which means that
submitted to an evaluation it should be oscillating between 50 and 950
mill volts, always bordering on minimum and maximum.
All
other sensors:
Make sure that all other vehicle sensors are in good working
condition, the full flex unit needs the proper data to run engine
controls to allow normal driving conditions to be met.
Cold
Start or Winter Driving
As no two vehicles are created the same with fuel management systems
and fuel delivery systems one of the few thing that exists in a vehicle
running an after market Bi Fuel converter system is some vehicle
experience a hesitation on the normal start running E85. As there is no
exact solution for this right now, what we have found that a simple
solution is merely adding about 6 gallons of gas to your E85 mix.
Download
Full Flex Manual
Installation Instructions
|
Online Distributor
