|
Full Flex E85 Conversion Kit Installation Instructions
|
|
Step One
|
|
Locate the fuel injection connectors. Injectors can be almost
any color.
In the picture below, the connectors are yellow. Injectors are
located above the
valve cover in the intake manifold.
|
|
|
| |
|
Step Two
|
|
Release the fuel injection connector. There are six types of
connectors.
Each has its own unique release method of depressing a quick
release.
|
|
|
| |
|
Step Three
|
|
The picture below shows one set of male and female connectors on
the Full Flex. Take all sets and pull them through the engine
compartment and bring them close to each injector. It's easier
to pull the connectors through the engine compartment that it is
the pull the Full Flex computer. So find a good mounting spot
and then fish your wires. .
|
|
|
| |
|
Step Four
|
|
Now we plug the connector on the fuel injector and the
other
connector will plug into the fuel injection wiring
harness.
|
|
|
|
|
| |
|
Step Five
|
|
Connect the black ground wire on the negative battery
terminal or a grounding
point within the engine compartment.
|
|
|
|
| |
|
Step Six
|
|
Double Check that all of the are plugged snuggly. Mount
the Full Flex with double sided tape or zip ties. Also
make sure that the Full Flex cables are not touching any
hot surfaces. Use lots of zip ties to make sure the wires
wont move over time.
|
|
|
|
|
|
Your Full Flex Gold is installed! Start your engine and
make sure that it is running smoothly and
the check engine light remains off.
|
| |
|
Step Seven
|
|
Upon completion of the installation, drive for about ten
miles. If your vehicle is running smoothly and the check
engine light remains off, then head to your E85 Station.
Fill up the vehicle with 50% of gasoline and 50% of E85.
This will allow the system to create a map of the burning
process. Your next tank should be all E85. Subsequent fill
ups can be any combination of gas or ethanol.
|
|
Online Distributor
